In this paper a new single ended fault location method is proposed for underground cable combined with overhead lines. In this algorithm fault clearing high frequency transients are used instead of fault-generated transients and the line parameters are not needed. In the proposed algorithm, samples just from voltage transients generated by fault clearing action of circuit breaker are taken from the sending end of the cable line. Applying wavelet transform, the first three inceptions of traveling waves to the fault locator are detected. Using these, the proposed algorithm at first identifies fault section, overhead or cable, and then wave speed is calculated and at last location of fault is determined accurately. Because of using only voltage samples taken from one terminal, it is simple and economic and does not need to GPS and data communication and synchronization. Extensive simulations carried out using SimPowerSystem toolbox of MATLAB, confirm the capabilities and high accuracy of the proposed method under different system and fault conditions.

Keywords