The present study attempts to investigate the effects of different chemical agents and chemical ratios on pore structure of coal based activated carbons. The adsorption isotherm data of two series of activated carbons prepared from bituminous coal by chemical activation with potassium hydroxide and zinc chloride were used. Four well-knownmodels of Dubinin-Stoeckli, Stoeckli, Horvath-Kawazoe, and improved Horvath-Kawazoe were applied for the characterization of these porous solids. Although the results showed some differences among the models that arise from their fundamental assumptions, in general they are found to be comparable. Results showed that samples activated by ZnCl2 provide higher-adsorption capacity than those from KOH. In each series, it was shown that the pore volume increases with increasing impregnation ratio, ranging from 50% to 200%. Activated carbons obtained at low chemical ratio in ZnCl2 series (up to 100%) showed microporous structure, while those with higher ratios became predominantly mesoporous. In the KOH series, increasing KOH created more micropores in the carbon structure in the whole range of studied chemical ratio.

Keywords