Title : ( Taguchi parametric study on the radial and tangential cutting forces in Dry High Speed Machining (DHSM) )
Authors: H. Safari , Mohammad Hatami ,
دانلود فایل برای اعضای دانشگاهAccess to full-text not allowed by authors
Abstract
In this paper, L 8 Taguchi array is applied to find the most important parameter effects on the radial and tangential cutting forces of a Ti–6Al-4V ELI titanium alloy in dry high speed machining (DHSM). The experiments are performed in four cutting speeds of 150, 200, 250, and 300 m/min and two feed rates of 0.03 and 0.06 mm/rev. Also, two cutting tools in types of XOMX090308TR-ME06 of uncoated (H25) and TiAlN+TiN coated (F40M) are used. Results confirm that to minimize the resultant cutting force and radial cutting force, using the lower feed rate (0.03 mm/rev) and higher cutting speed (300 m/min) were considered as the best levels of studied factors.
Keywords
cutting force; titanium alloy; high speed machining; Taguchi method.
@article{paperid:1084766,
author = {H. Safari and Hatami, Mohammad},
title = {Taguchi parametric study on the radial and tangential cutting forces in Dry High Speed Machining (DHSM)},
journal = {Metallurgical and Materials Engineering},
year = {2020},
volume = {26},
number = {3},
month = {September},
issn = {2217-8961},
pages = {303--316},
numpages = {13},
keywords = {cutting force; titanium alloy; high speed machining; Taguchi method.},
}
%0 Journal Article
%T Taguchi parametric study on the radial and tangential cutting forces in Dry High Speed Machining (DHSM)
%A H. Safari
%A Hatami, Mohammad
%J Metallurgical and Materials Engineering
%@ 2217-8961
%D 2020
