Thumb carpometacarpal joint space changes when the surrounding soft tissues including the capsule, ligaments, and tendons are stretched or pulled away. When at rest, joint forces originate from passive contraction of muscles and the involvement of joint capsule and ligaments. Previous biomechanical models of hand and finger joints have mostly focused on the assessment of joint properties when muscles were active. This study aims to present an experimental-numerical biomechanical model of thumb carpometacarpal joint to explore the contribution of tendons, ligaments, and other soft tissues in the passive forces during distraction. Five fresh cadaveric specimens were tested using a distractor device to measure the applied forces upon gradual distraction of the intact joint. The subsequent step involved inserting a minuscule sensor into the joint capsule through a small incision, while preserving the integrity of tendons and ligaments, in order to accurately measure the fundamental intra-articular forces. A numerical model was also used to calculate the passive forces of tendons and ligaments. Before the separation of bones, the forces exerted by tendons and ligaments were relatively small compared to the capsule force, which accounted for approximately 92% of the total applied force. Contribution of tendons and ligaments, however, increased by further distraction. The passive force contribution by tendons at 2-mm distraction was determined less than 11%, whereas it reached up to 74% for the ligaments. The present study demonstrated that the ligament-capsule complex plays signifcant contribution in passive forces of thumb carpometacarpal joint during distraction.

Keywords